How to Install Solid Wood Floors in Bathrooms

This entry was posted in Uncategorized on by .

Are you planning to transform your bathroom space, cabinets and solids with hardwood flooring? Do you still consider it as a doubtful decision?


Just follow the steps below and see how you can install wooden flooring in a bathroom easily. Experienced handymen in New Jersey suggest you to do the following:

Opting For Appropriate Flooring

Continuing dampness and humidity is a major factor that can weigh the selection of correct bathroom flooring. The concern might show results like cupping or swelling with wooden portions and can come up as obvious gaps.

Floor boards that are engineered in vertical layers like plywood are more flat for moments and diminish chances for development of gaps.

However, it’s suggested that essentials like warranty and specifications about product installation must be taken under priority.

Setting up the Subfloor

Subfloor is the prior level of floor that sets the foundation for wooden flooring. This former step is directly dependent on the floor type you have.

For instance, with a plywood floor, fill the reoccurring gaps with leveling compound. In case of a concrete floor, you will have to level the bumping surface with hammer knocks.

Subsequent to this, protect the base with a good moisture barrier. For this purpose use plastic or tar paper, assuring that no gaps with wall ends are left undone.

In case, you notice deposits of moisture on the plastic after few days of installation, the surface should be left open so that it dries off completely.

Installing Solid Wood Floors

Wooden floorboards that are directly glued to the concrete floor will get alleviated with moisture mounting in the bathroom. However, covering the concrete flooring with appropriate moisture barrier is a more suggestive approach for such concerns.

You can directly nail the barrier to the floor or rest them in rectangular sleepers. The implication will even be a plus for room insulation.

With installation of wooden floors, the surface will get elevated and there might be a need to trim the doors from bottom. Similarly, you will have to come up with suitable transitions where new floor assembles with the present one.

Nail the Wooden Floor

When you done with subfloor, the only step you are left with is to nail down the wooden flooring. If you have previously done wooden flooring in any house space, the steps are roughly the same.

For first timers, start laying 1- 2 course of wooden flooring along the wall and gradually move towards the core of the space. However, remember to drive the nails through floor and secure them with the wall.

Moreover, minor gap between flooring and wall should be left unoccupied. This space will be taken when the flooring start expanding and consequently diminishes the chances of split openings.

Leave a Reply

Your email address will not be published. Required fields are marked *